Shadow Convertible L4-153 2.5L SOHC Turbo (1991)
Figure 1
Service Procedure
1.
Open the hood and verity that both the right and left air bag system front impact sensors (Figure 1) are mounted to the radiator closure panel
with a mounting plate and three (3) attaching bolts.
^
If properly mounted, no further action is required.
^
If not mounted, complete steps 2 through 6.
2.
Order the required number of impact sensor mounting plates (two per car), PN 6502044, and mounting bolts (six per car), PN 6501888.
3.
With the ignition key in the off position, disconnect the battery.
4.
Mount each front impact sensor using a mounting plate and three bolts.
5.
Tighten the bolts to 100 in.lbs. (11.3 N-m).
6.
Connect the battery and check for proper operation of the air bag warning system. At initial key-on, the air bag light will illuminate for 6 or 8
seconds and then go out.
Completion Reporting and Reimbursement
Completion Reporting and Reimbursement
Claims for vehicles which have been serviced must be submitted on the DIAL System. Claims submitted will be used by Chrysler to record recall service
completions and provide dealer payments.
Use one of the following labor operation numbers and time allowances:
Labor Operation
Time
Number
Allowance
Inspect air bag sensor attachments
08495181
0.2 Hour
Inspect and attach air bag sensors
08495182
0.3 Hour
Add the cost of any parts used plus applicable dealer allowance to your claim.
Note:
See Warranty Policy and Procedure Manual, Chapter 6, Subsection H for complete recall claim processing instructions.
Parts Return
