dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Blend Door Actuator Replacement|Page 4222 > < Blend Door Actuator Replacement
Page 1
background image

Air Door Actuator / Motor: Service and Repair
Mode Door Actuator Replacement

CAUTION:  Do not remove any of the motor actuators from the Heater/AC unit assembly with any electrical power applied. Removal should only be
done with the ignition OFF and battery cable removed. The actuators have no mechanical stops to limit their travel. if the actuator rotates and is not
connected to the unit assembly, it will become un-calibrated.

REMOVAL AND INSTALLATION

1. Remove under panel silencer.
2. Disconnect electrical connector from actuator.

Mode Door Actuator

3. Pinch and remove the lower plastic clip from the actuator arm.

Actuator Bracket Mounting Screws

4. Remove the three actuator bracket mounting screws.
5. Rotate actuator to gain access to upper plastic clip. Pinch and remove the upper plastic clip from the actuator arm.
6. Remove actuator-to-actuator mounting bracket screws.
7. Remove actuator from mounting bracket. Remove from vehicle.

To install, reverse the preceding operation.

Blend Door Actuator Replacement|Page 4222 > < Blend Door Actuator Replacement