Shadow Convertible L4-153 2.5L SOHC VIN K TBI (1992)
Gauge Calibration Chart
4.
Compare measured resistance to the Gauge Calibration Chart.
Multiple Gauge Malfunction
Printed Circuit Board Connectors
If the Voltmeter, Speedometer, Tachometer, and other gauges appear to be malfunctioning, proceed as follows:
1.
Remove the cluster.
2.
Check for ignition voltage at pin E of the red cluster connector.
^
If voltage is not present, repair open circuit.
3.
Check for ground continuity between pin C of the red cluster connector.
^
If a good ground is not present, repair open circuit.
4.
If circuits are OK and pins or connectors are not distorted, replace the printed circuit board.
