Shadow Convertible L4-153 2.5L SOHC VIN K TBI (1992)
Fig. 2 End Plate Retaining Ring Removal
2. Remove pump end plate retaining ring as follows:
a. Position a socket (1) on the pump shaft and end plate.
b. Mount pump and sockets in a vise as shown.
c. Tighten fixture slightly to compress spring under end plate.
WARNING: End plate is under spring pressure. Use caution when removing retaining ring to avoid personal injury.
d. Insert a punch (2), into access hole in pump and push ring outward.
e. Remove retaining ring (3), with a screwdriver, release vise jaws and remove pump and sockets from vise.
Fig. 3 End Plate Removal
3. Place pump into vise with wood blocks between shaft end of pump housing and vise jaws.
4. Remove end plate by gently rocking back and forth, or tapping with a soft mallet.
