Shadow Convertible V6-181 3.0L SOHC VIN 3 FI (1993)
3.
Drill a 4 mm (5/32") hole approximately 26 mm (1") rearward of the existing front rivet on the metal retaining bracket. Use Mopar Scratch Filler
Primer (P/N 4436636) or equivalent on the new hole. Install rivet P/N 6032731 through the retaining bracket and door. Refer to Figure 2. Remove
the front rivet if it is broken or loose and seal the hole with RTV. Do not install another rivet in this location.
4.
Re-install the lower door applique over the metal retaining bracket making sure not to extend the applique beyond the front edge of the door.
Install 9 rivets, P/N 6032856 through the lower edge of the applique.
5.
Repeat steps 1-4 for the opposite door if necessary.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No.
23-02-37-96
0.5 Hrs.
FAILURE CODE: K4 - Loose
