dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

All Technical Service Bulletins: > < A/T - High Effort Is Required to Disengage Park|Page 3599
Page 1
background image

Shift Cable: Customer Interest
A/T - High Pitched Whine

Models

1984-1987 Two & Four Door Dodge Omni & Plymouth Horizon

Subject

High Pitched Whine

Index

TRANSMISSION

Date

February 2, 1987

No..

21-02-87 (C3-21)

P-0267
This bulletin supersedes Technical Service Bulletin 21-10-86. This revision expands bulletin 21-10-86 to include all subject model vehicles built prior to
October 22, 1986.

SYMPTOM/CONDITION

Transfer gear set noise (high pitched whine) from the automatic transaxle during coast down in the 45-35 mph range.

DIAGNOSIS

Vehicle should be evaluated on a smooth quiet road surface, and be warmed up to normal operating temperatures.

Accelerate past 45 mph and coast through the 45-35 mph range, checking for a high pitched whine. If the whine is present, replace the gearshift control
cable.

PARTS REQUIRED

1

Gearshift Control Cable

PN 4377301

REPAIR PROCEDURE

1.

Remove old gearshift control cable, using appropriate service manual.

2.

Replace with new cable, PN 4377301. Route the cable between the carpet and the underlayment.

3.

Adjust gearshift linkage according to appropriate service manual.

4.

Road test to verify proper operation.

POLICY:

Reimbursable within the provisions of the warranty

TIME ALLOWANCE:

Refer to Labor Operation Time Schedule for operation and time

FAILURE CODE:

68 - Noisy

All Technical Service Bulletins: > < A/T - High Effort Is Required to Disengage Park|Page 3599