Spirit L4-153 2.5L SOHC Flex Fuel (1995)
Trim Panel: Service and Repair
Interior Mouldings, Panels, And Trim Covers
COWL PANEL AND DOOR OPENING SCUFF PLATE REMOVAL
1. Open front door.
2. Remove screw holding trim panel to cowl forward of the front door opening.
3. Remove screws holding scuff plate to door sill.
4. Separate cowl panel trim and scuff plate from vehicle.
5. Reverse the preceding operation for installation.
REAR DOOR OPENING SCUFF PLATE REMOVAL
1. Open rear door.
2. Remove screws holding scuff plate to door sill.
3. Separate scuff plate from vehicle.
4. Reverse the preceding operation for installation.
A-PILLAR AND ROOF RAIL MOULDINGS
The A-pillar mouldings on the passenger side of vehicles built for export to Canada and Mexico are serviced using the same procedures as the
driver side.
A-PILLAR MOULDING REMOVAL
1. Open front door.
2. Disengage clips holding A-pillar moulding to roof rail above door opening.
3. Slide A-pillar moulding upward and pull rearward to separate moulding from A-pillar.
4. Reverse the preceding operation for installation.
REAR DOOR ROOF RAIL MOULDING REMOVAL
1. Open rear door.
2. Disengage clips holding roof rail moulding to roof rail above rear door opening.
3. Separate moulding from vehicle.
4. Reverse the preceding operation for installation.
B-PILLAR TRIM PANEL
The B-pillar mouldings on the passenger side of vehicles built for export to Canada and Mexico are serviced using the same procedures as the
driver side.
B-PILLAR TRIM PANEL REMOVAL
1. Remove roof rail mouldings and scuff plates as necessary.
2. Remove shoulder harness turning loop cover. Remove bolt holding turning loop to B-pillar.
3. Remove bolt holding seat belt to floor below B- pillar.
4. Lift B-pillar trim off door opening sill weather- strips and push inward.
5. Slide B-pillar trim downward as far as possible and separate trim from B-pillar.
6. Reverse the preceding operation for installation.
