Spirit V6-181 3.0L SOHC (1990)
Trim Panel: Service and Repair
Garnish Mouldings And Trim Panels
INTERIOR TRIM PANELS AND GARNISH MOULDINGS
Excellent fit and appearance are two benefits of overlapping garnish and trim panels on the interior of the vehicle. A series of trim components
must be removed in order to service trim panels or garnish mouldings. The following list is the sequence of installation to be most effective.
1. Install deck lid and fuel door release cover.
2. Install B-pillar seatbelt retractors.
3. Install B-pillar trim after routing the seat- belt through the opening in the trim panel.
4. Secure B-pillar seatbelts upper turning loop and lower sill attachment.
5. Install side cowl trim.
6. Install A-pillar trim (snap in).
7. Install rear seat back latch striker assembly.
8. Install rear seat bolster support brackets.
9. Install center high mounted stop lamp.
10. Install shelf trim panel.
11. Secure center high mounted stop lamp cover.
12. Install quarter trim panel side extensions (snap in).
13. Install rear shoulder belts.
a. Snap in plastic shield in quarter inner panel.
b
Secure retractor assembly.
14. Install quarter trim panels.
a
Snap in dual lock fastener in quarter inner panel.
b
Route shoulder belt through opening in trim panel before installing.
c
Secure lower shoulder belt attachment.
d
Secure trim panel.
e
Secure shoulder belt upper turning loop.
f
Snap-On upper turning loop trim cover.
15. Install rear door roof rail garnish moulding (snap in).
16. Install rear door sill scuff cover.
17. Install rear inboard seatbelts.
18. Install rear seat bolsters.
19. Install rear seats.
SIDE COWL TRIM PANEL
1. Remove screws from scuff plate and cowl trim.
2. Remove lower most clip from "A" post garnish moulding.
3. Remove side cowl and scuff plate trim panel.
4. Reverse this procedure to install.
"A" POST AND SIDE GARNISH MOULDING
1. Remove "A" post and side garnish moulding.
