dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Air Bag Systems|Air Bag > < Solar Sensor, HVAC|Diagrams|Page 5892
Page 1
background image

Air Bag(s) Arming and Disarming: Service and Repair

Air Bag System Arming and Disarming

NOTE:  Access and record all fault (trouble) codes prior to disarming the Supplemental Restraint System (SRS).

1. Place ignition switch in lock position.
2. Disconnect and insulate the negative battery cable connector with electrical tape.
3. Wait at least 2 minutes after disconnecting battery before working on vehicle. The SRS system retains enough voltage to deploy airbag

for a short time after battery has been disconnected.

4. After repairs are complete, connect battery ground cable.
5. From passenger side of vehicle, turn ignition switch to ON position.
6. SRS warning light should illuminate for 6 to 8 seconds, then remain off for at least 45 seconds to indicate SRS system is functioning correctly.
7. If SRS indicator does not perform as described Refer to Testing and Inspection.  See: Testing and Inspection/Initial Inspection and Diagnostic

Overview

Air Bag Systems|Air Bag > < Solar Sensor, HVAC|Diagrams|Page 5892