Sprinter 2500 L5-2.7L DSL Turbo (2003)
5
Prepare window cutout of rear door for installation
Not more than 1 mm of the adhesive bead must remain.
Pull off loose adhesive material (remaining pieces which are not completely cut off). Repair paint damage on body flange not covered by glue
material.
A. Without body and paintwork
1
Clean window cutout.
2
Level remaining bead of glue to a thickness of approx. 1 mm with scraper.
3
Evacuate window cutout.
4
Dab possible paint damage in the gluing area with primer. Repair paint damage in the visual area with top coat paint.
Allow primer to air-dry for at least 10 minutes
B. On body and paintwork
1
Perform body work.
2
Perform paintwork.
3
Clean window cutout.
4
Level remaining bead of glue to a thickness of approx. 1 mm with scraper
5
Apply primer to painted gluing surface.
Allow primer to air-dry for at least 10 minutes. If more than 12 hours have expired since leveling the bead of glue in the window cutout apply
primer to bead of glue.
