Sprinter 2500 L5-2.7L DSL Turbo (2003)
Camshaft: Removal and Replacement
CAMSHAFT(S)
REMOVAL
1. Disconnect negative battery cable.
2. Remove engine cover.
WARNING: Refer to FUEL SYSTEM - WARNING
3. Remove high pressure lines and injectors.
4. Remove cylinder head cover.
NOTE: Rotate engine at the crankshaft only. DO NOT rotate the engine at the camshaft. DO NOT rotate the engine backward.
5. Position piston of cylinder #1 to ignition TDC.
6. Lock inlet camshaft (Fig. 19).
7. Remove timing chain tensioner.
NOTE: The lower portion of the cylinder head front cover is sealed with RTV sealant. Carefully tug front cover after bolt removal to loosen from
cylinder head.
8. Remove cylinder head front cover.