Sprinter 2500 L5-2.7L DSL Turbo (2003)
Pulley Snap Ring
7. Using snap ring pliers (Special Tool C-4574 or equivalent), remove the external snap ring that secures the compressor clutch pulley to the front of
the compressor, then slide the pulley off of the compressor.
8. Remove the screw that secures the clutch coil wire harness connector bracket and ground clip to the top of the compressor housing.
Clutch Coil Snap Ring
9. Using snap ring pliers (Special Tool C-4574 or equivalent), remove the external snap ring that secures the compressor clutch coil to the front of
the compressor, then slide the clutch coil off of the compressor.
INSTALLATION
1. Align the dowel pin on the back of the clutch field coil with the hole in the compressor front cover, and position the clutch coil onto the
compressor. Be certain that the clutch coil wire harness leads are properly oriented and routed so that they are not pinched between the compressor