Sprinter 2500 L5-2.7L DSL Turbo (2003)
Blower Motor Relay: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the cover from the rear evaporator housing.
3. Refer to the relay block for blower motor relay identification.
4. Unplug the blower motor relay from the relay block and remove it.
INSTALLATION
1. Install the blower motor relay by aligning the relay terminals with the cavities in the relay block and pushing the relay firmly into place.
2. Install the rear evaporator cover.
3. Reconnect the battery negative cable.