Sprinter 2500 L5-2.7L DSL Turbo (2003)
Evaporator Temperature Sensor / Switch: Service and Repair
Temperature Sensor
REMOVAL
1. Disconnect and isolate the battery negative cable.
Rear Roof Duct Panel
2. Remove the rear dome light from the rear roof duct panel.
3. Disconnect the dome light wire harness connector and remove the dome light from vehicle.
4. Remove the six push-pin roof duct panel fasteners and remove the duct panel from the vehicle.
5. Locate the air temperature sensor within the evaporator housing and disconnect the wire harness connector.
6. Remove the temperature sensor retainer and remove the sensor from the vehicle.
INSTALLATION
1. Install the temperature sensor and retainer into the rear evaporator housing.
2. Connect the temperature sensor wire harness connector.
3. Install the rear duct panel and the six push-pin duct panel fasteners.
4. Connect the dome light wire harness connector and install the dome light into the rear duct panel.
5. Reconnect the battery negative cable.
