Sprinter 2500 L5-2.7L DSL Turbo (2003)
6. Remove and discard rubber gasket (seal) from tank module.
INSTALLATION
CAUTION: Whenever the fuel tank module is serviced, the rubber gasket must be replaced.
1. Thoroughly clean locknut (lockring) and locknut threads at top of tank.
2. Using new gasket, carefully position fuel tank module into opening in fuel tank.
3. Position locknut over top of fuel tank module. Install locknut finger tight.
Align Tank Module
4. Both fuel line fittings should be pointed to the right side of the vehicle. Rotate and position alignment arrow towards right side of vehicle (if
necessary) before tightening locknut. This step must be performed to prevent the module's float from contacting the side of fuel tank.
5. Tighten locknut using Special Tool #6856. Refer to Torque Specifications.
6. Install fuel tank. Refer to Fuel Tank removal/installation.
