Sprinter 2500 L5-2.7L DSL Turbo (2003)
Seat Belt: Service and Repair
Rear Seat Belt and Retractor
WARNING: DURING AND FOLLOWING ANY SEAT BELT SERVICE, CAREFULLY INSPECT ALL SEAT BELTS, BUCKLES,
MOUNTING HARDWARE, RETRACTORS, AND ANCHORS FOR PROPER INSTALLATION, OPERATION, OR DAMAGE. REPLACE
ANY BELT THAT IS CUT, FRAYED, OR TORN. STRAIGHTEN ANY BELT THAT IS TWISTED. TIGHTEN ANY LOOSE FASTENERS.
REPLACE ANY BELT THAT HAS A DAMAGED OR INOPERATIVE BUCKLE OR RETRACTOR. REPLACE ANY BELT THAT HAS A
BENT OR DAMAGED LATCH PLATE OR ANCHOR PLATE. NEVER ATTEMPT TO REPAIR A SEAT BELT COMPONENT. ALWAYS
REPLACE DAMAGED OR FAULTY SEAT BELT COMPONENTS WITH THE CORRECT, NEW AND UNUSED REPLACEMENT
PARTS LISTED IN THE DAIMLERCHRYSLER MOPAR PARTS CATALOG.
REMOVAL
1. Remove the rear bench seat containing the rear seat belt and retractor unit to be serviced from the vehicle.
Turning Loop Trim Cover
2. Lift the seat belt webbing to access and remove the plastic push pin fastener that secures the rear seat belt turning loop trim cover to the turning
loop bracket at the top of the seat back.
3. Remove the turning loop trim cover from the turning loop bracket.
Rear Seat Belt Turning Loop
4. Remove the push nut at the back of the turning loop bracket that secures the pin on which the two turning loops pivot.
