Sprinter 2500 L5-2.7L DSL Turbo (2003)
Rear Seat Belt Retractor
10. Remove the screw that secures the rear seat belt retractor to the bracket on the rear seat cushion frame.
11. Remove the rear seat belt and retractor unit from the bracket on the rear seat cushion frame.
INSTALLATION
1. Position the rear seat belt and retractor unit onto the bracket of the rear seat cushion frame. Be certain to engage the guide on the retractor into the
locating notch on the bracket.
2. Install and tighten the screw that secures the rear seat belt retractor to the bracket on the rear seat cushion frame. Tighten the screw to 35 N.m (26
ft. lbs.).
3. Route the rear seat belt and lower anchor through the turning loop bracket and the turning loop trim cover.
4. Position the rear seat belt lower anchor to the rear seat cushion frame.
5. Install and tighten the screw that secures the rear seat belt lower anchor to the rear seat cushion frame. Tighten the screw to 35 N.m (26 ft. lbs.).
6. For a left outboard seating position only, reinstall the plastic cover onto the screw that secures the rear seat belt lower anchor to the left outboard
side of the seat frame.
7. Position the two seat belt turning loops to the turning loop bracket so that one turning loop is located behind the bracket and one is located in front
of the bracket.
8. From the front of the turning loop bracket, insert the pin through both turning loops and the bracket, then secure it from behind the bracket with a
new push nut.
9. Position the turning loop trim cover over the turning loop bracket.
10. Lift the seat belt webbing to access and install the plastic push pin fastener that secures the rear seat belt turning loop trim cover to the turning loop
bracket at the top of the seat back.
11. Reinstall the plastic shield onto the back of the rear seat.
12. Reinstall the rear bench seat into the vehicle.
