Sprinter 2500 L5-2.7L DSL Turbo (2003)
Cargo Lamp Switch: Service and Repair
Instrument Panel
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the accessory switch bezel from the instrument panel.
Cargo Lamp Switch - Accessory Switch Bezel Mounted Remove/Install
3. From the back of the accessory switch bezel, disconnect the vehicle wire harness connector for the cargo lamp switch from the receptacle on the
back of the switch.
4. From the back of the accessory switch bezel, depress the two latches on the outside of the switch body and push the switch out through the front of
the bezel.
INSTALLATION
1. From the front of the accessory switch bezel, align the cargo lamp switch body with the opening in the bezel and push the switch into the bezel
until the two latches on the outside of the switch body snap into place.
2. From the back of the accessory switch bezel, reconnect the vehicle wire harness connector for the cargo lamp switch to the receptacle on the back
of the switch.
3. Reinstall the accessory switch bezel onto the instrument panel.
4. Reconnect the battery negative cable.
