Sprinter 2500 L5-2.7L DSL Turbo (2003)
a. Using Bearing Installer 9287 (Fig. 177), install the output shaft bearing into the transmission housing. The closed side of the plastic cage must
point towards the parking lock gear.
b. Install the retaining ring (Fig. 178). Ensure that the retaining ring is seated correctly in the groove.
c. Check that there is no play between the bearing and the retaining ring using feeler gauge.
d. There must be no play between the retaining ring and the bearing. If the ring cannot be installed, a thinner ring must be used. If there is play
between the ring and the bearing, a thicker ring must be installed. Retaining rings are available in thicknesses of 2.0 mm (0.079 inch), 2.1 mm
(0.083 inch), and 2.2 mm (0.087 inch).
2. Install the output shaft washer onto the output shaft.
