Sprinter 2500 L5-2.7L DSL Turbo (2003)
2. Install rear axle shaft in the axle tube (Fig. 5).
3. Install new bearing cap bolts and tighten to 72 Nm (53 ft. lbs.) (Fig. 6).
NOTE: Tighten bolts diagonally across.
4. Install brake control cable lock.
5. Install parking brake shoes.
6. Install brake disk and calipers.
7. Coat clamping bush with acid free grease. Insert ABS sensor with clamping bush fully into the mounting hole.
8. Install front brake cable.
9. Operate brake pedal several times until brake pads contact brake discs (brake pressure built up).
10. Install wheels.
