Sprinter 2500 L5-2.7L DSL Turbo (2003)
Wiper Arm: Procedures
REMOVAL
Wiper Arm Remove/Install
1. Disconnect the washer nozzle hose from the elbow fitting on the cowl top panel near the pivot end of the wiper arm.
CAUTION: The use of a screwdriver or other prying tool to remove a wiper arm may distort it. This distortion could allow the arm to come off of
the wiper pivot during wiper operation, regardless of how carefully it is reinstalled.
2. Unsnap the end of the pivot cover from the wiper blade pivot end, then pull the cover away from the wiper arm hinge pin to remove the cover from
the wiper blade.
3. Remove the nut that secures the wiper arm to the wiper pivot shaft.
Wiper Arm Puller - Typical
4. If necessary, use a suitable battery terminal puller to disengage the wiper arm from the wiper pivot shaft.
5. Remove the wiper arm pivot end from the wiper pivot shaft.
INSTALLATION
NOTE:
-
Be certain that the wiper motor is in the park position before attempting to install the wiper arms. Turn the ignition switch to the On position and
