Sprinter 2500 V6-3.0L DSL Turbo VIN 45 (2007)
Rear Bumper Cover / Fascia: Service and Repair
Installation
INSTALLATION
Bumper Assembly
1. Install the Parktronic sensors (6, 7, 8, 9) and seat the retaining tabs fully.
2. Attach the Parktronic wiring harness (4) to the bumper (1).
3. Install the bumper corner upper sections (3) onto the bumper corners (2).
4. Install the bumper corners (2) onto the bumper (1).
5. Install the bumper.
Bumper Installation
1. Position the bumper (1) together with the bumper corners (2) onto the vehicle.
2. Install the collar bolts (3) and tighten to 9 Nm (80 in. lbs.).
3. Connect the Parktronic sensor (9) electrical connector.
4. Install a new cable strap (7).
5. Install the clips (9) at the bottom of the bumper (1).
6. Secure the bumper corner upper sections (6) on the left and right from side wall, and seat fully.
7. Install the clips (5) onto the bumper corners (2).
8. Connect the marker lamp electrical connector on the protective strips (4).
9. Install the protective strips (4) and seat clips fully.
10. Install the protective strip screws in the wheel wells.
