Sprinter 2500 V6-3.0L DSL Turbo VIN 45 (2007)
1. Disconnect and isolate the battery negative cable.
2. Remove the front door trim panel (2). Refer to Trim Panel.
3. Remove the bolts (4) and remove the keyless entry antenna (2). Disconnect the electrical connector (3).
4. Disconnect the electrical connectors (5), un-clip and remove the control unit (8).
5. Disconnect the electrical connector (43), remove the screws (42) and remove the speaker (45).
6. Disconnect the electrical connector (6), remove the screws (7) and remove the speaker.
CAUTION: Do not allow the watershield or adhesive to become contaminated with dirt or other foreign substances.
Do not damage the watershield during removal and installation.
If the watershield becomes contaminated or damaged, replace the watershield.
7. Carefully remove the watershield (9) from around the perimeter of the door.
Installation
INSTALLATION
CAUTION: Do not allow the watershield or adhesive to become contaminated with dirt or other foreign substances.
Do not damage the watershield during removal and installation.
If the watershield becomes contaminated or damaged, replace the watershield.
