Sprinter 2500 V6-3.0L DSL Turbo VIN 45 (2007)
1. Remove the rear end door inner latch handle (2).
2. Remove the rear end door inner latch and press toward inside, Door Latch - Left Door Inner.
NOTE: The bottom door latch (2) can only be removed if the rear end door inner latch has been released previously.
NOTE: Using a grease pencil or equivalent, mark the position of the upper door latch to aid installation.
3. Remove the bottom door lock bolts (1).
4. Unhook cable (3) from bottom door latch (2).
Installation
INSTALLATION
Door Latch - Left Door Inner
CAUTION: Carefully guide cables when removing and installing to prevent damaging rattling protection.
1. Connect the upper door latch cable (12) and the lower door latch cable (13).
2. Position the rear end door inner latch (6) into the door with cables.
3. Connect the bottom door latch cable (13) and install the bottom door latch (8).
4. Connect the upper door latch cable (12) and install the upper door latch (2).
5. Position the inner door latch (6) into the door interior and install the bolts (9).
6. Tighten the bolts (9) to 8 Nm (70 in. lbs.).
7. Install the top/bottom door trim (4, 5).
