Sprinter 2500 V6-3.0L DSL Turbo VIN 45 (2007)
Sliding Door Window Glass: Service and Repair
Installation
INSTALLATION
1. Prepare side window cutout for installing.
a. Ensure that not more that 1 mm (0.03 in) of adhesive bead remains.
b. Pull off loose adhesive material (remaining pieces which are not completely cut off).
c. Repair paint damage not covered by glue with primer.
2. Prepare the side window for installing.
3. Install sealing frame on body flange.
4. Install three spacers on window to prevent window from falling down. One spacer on the outside is sufficient for correct side alignment.
NOTE: Open the driver window. This prevents the side window from being pressed outwards by the air pressure when a door is closed
before the bond has completely cured.
5. Install the side window.
NOTE: Install the side window within 5 minutes before the adhesive force of glue starts to decrease.
6. Remove the spacers after curing time.