Sprinter 2500 V6-3.0L DSL Turbo VIN 45 (2007)
4.
Remove the plastic backing from one side of the small piece of Velcro(R) (2.5" x 2") and install it on the short side of the back of each head
impact protection pad as shown in Figure 2. Leave approximately 1/2 in. (13 mm) gap between the Velcro(R) strip and the divider (Figure 2).
NOTE:
The new piece of Velcro® will cover the original piece of Velcro(R) that came on the head impact protection pad.
5.
Remove the plastic backing from one side of the large piece of Velcro(R) (4.5" x 2") and install it on the long side of the back of each head impact
protection pad as shown in Figure 2. Leave approximately 1/2 in. (13 mm) gap between the Velcro® strip and the divider (Figure 2).
