Sprinter 2500 V6-3.0L DSL Turbo VIN 45 (2007)
Trim Panel: Service and Repair
Backlite - Bulkhead Trim Panel
Removal
REMOVAL
1. Position an assistant opposite side of the bulkhead trim panel to receive the glass and weatherstrip seal.
2. Start at an upper corner and separate the seal from the window opening. Push the glass and seal outward from the window opening. Remove the
glass and seal.
3. Remove seal from glass if necessary.
4. Clean the window opening.
Installation
INSTALLATION
1. Install the weatherstrip seal on the window glass. Verify that the glass is seated in the groove around the edge of the seal.
2. Insert an installation cord in the weatherstrip seal inner groove.
NOTE: Use mineral spirits as a lubricant to aid seal installation in the window opening.
3. Position the glass and seal in the trim panel opening.
4. Pull the installation cord outward and force the seal lip over the panel flange around the edge of the opening.
5. Seat the seal inner lip on the panel flange. Press against the lip around the edge of the seal.
NOTE: Remove any mineral spirits with a clean cloth after glass installation.
6. Verify that the seal is seated in the trim panel opening.
