Sprinter 2500 V6-3.0L DSL Turbo VIN 45 (2007)
Seat Heater: Service and Repair
Removal
REMOVAL
NOTE: Do not remove the factory installed heating elements (3) from the seat or seat back cushions. The original element is permanently attached and
cannot be removed without permanent damage. The replacement heating element is designed to be applied directly on top of the inoperative factory
installed heating element.
1. Disconnect and isolate the negative battery cable.
2. Remove the appropriate seat cushion or seat back trim cover.
3. Disconnect the inoperative heated seat cushion or seat back element electrical connectors (1 & 2).
4. Locate the wires leading from the inoperative heating element and cut them off flush with the edge of the original heating element.
