Sprinter 2500 V6-3.0L DSL Turbo VIN 45 (2007)
Wheel Speed Sensor: Service and Repair
Tone Wheel
Removal - Dual Rear Wheel (DRW)
REMOVAL - DUAL REAR WHEEL (DRW)
NOTE: The tone wheel for single rear wheel (SRW) is integrated into the wheel hub/bearing assembly and not serviced separately.
1. Remove the hub/bearing assembly.
2. Insert a hooked prybar (1) between the hub/bearing and the inside of the tone wheel and pry upwards slightly and work your way around the tone
wheel until the wheel is loose.
3. Remove the tone wheel (2).
Installation - Dual Rear Wheel (DRW)
INSTALLATION - DUAL REAR WHEEL (DRW)
1. Install the tone wheel to the hub/bearing with a thin bead of silicone around the tone wheel.
2. Tap the tone wheel down with a soft hammer until seated.
3. Install the hub/bearing.