Sprinter 2500 V6-3.0L DSL Turbo VIN 45 (2007)
Parking Brake Cable: Service and Repair
Installation
Front Cable
FRONT CABLE
1. Install the front park brake cable to the vehicle.
2. Install the front park brake cable (3) to the hand brake lever (2).
3. Install the trim (1) for the park brake lever.
4. Install the rubber grommet (3).
5. Clip the cable guides at the frame cross member (2).
6. Reconnect the front park brake cable (1) to the pulley unit.
7. Adjust the parking park.
8. Lower the vehicle.
Rear Cable - Single Rear Wheel (SRW)
REAR CABLE - SINGLE REAR WHEEL (SRW)
NOTE: Route the park brake cable free of tension and the risk of chafing.
1. Install the park brake cable.
2. Install all tie straps for the brake cable.