Sprinter 2500 V6-3.0L DSL Turbo VIN 45 (2007)
Radiator Cooling Fan: Service and Repair
Removal
3.0L DIESEL
1. Disconnect the negative battery cable. See: Starting and Charging/Battery/Battery Cable/Service and Repair
2. Detach coolant line from lower radiator shroud.
NOTE: The radiator fan assembly is attached (threaded) to the water pump hub shaft. Remove the fan blade/viscous fan drive assembly
from the water pump by turning the mounting nut counterclockwise as viewed from the front. Threads on the radiator fan drive are
LEFT-HAND..
3. Using Counterholder 8930 (Item 2) to hold pulley, remove radiator fan. (Item 5)
4. Remove upper air seal.
5. Remove upper radiator hose.
6. Remove radiator fan shroud and radiator fan. See: Radiator/Service and Repair
NOTE: Store the viscous fan clutch in the upright position. DO NOT place down flat.
