Sprinter 2500 V6-3.0L DSL Turbo VIN 45 (2007)
5. Remove the vacuum pump.
6. Remove the oil level indicator tube (2) retaining bolt at the right cylinder head cover.
7. Remove the crankcase breather assembly (4) from the right cylinder head cover.
8. Remove the cylinder head cover.
NOTE: The right exhaust camshaft gear alignment mark is located in the gear tooth valley. The left intake camshaft gear mark is located
on the outside of the tooth.
9. Check the camshaft timing gears for alignment. The alignment marks should be touching and the exhaust camshaft drive gear alignment pin should
be located at approximately 12 o'clock, when viewed from the front camshaft seal.
10. Rotate the engine by the vibration damper bolt, past TDC to gain access to the lower camshaft drive gear bolt, and remove the bolt.
11. Rotate the engine back to TDC and check camshaft gear alignment.
12. Remove the timing chain tensioner (3).
