Sprinter 2500 V6-3.0L DSL Turbo VIN 45 (2007)
Intake Manifold: Service and Repair
Actuator-Swirl Valve
Removal
REMOVAL
1. Disconnect negative battery cable.
2. Remove the engine cover.
3. Drain the coolant.
4. Remove the strut tower support (2).
5. Remove the intake air housing and tube.
6. Remove the charge air cooler tube (4).
7. Remove the resonator.
8. Remove the EGR tube.
CAUTION: Observe the position of the turbocharger oil passage housing and gasket. Failure to properly position the gasket during
assembly will result in immediate turbocharger failure after assembly.
9. Remove the turbocharger
10. Disconnect the engine harness and position aside.
11. Disconnect the swirl valve actuator connector.
12. Remove the swirl valve actuator (3) clips.
13. Remove the swirl valve actuator.
Installation
INSTALLATION