Sprinter 2500 V6-3.0L DSL Turbo VIN 45 (2007)
Crankshaft Main Bearing Seal: Service and Repair
Installation
INSTALLATION
1. Apply sealant 1.5 mm (.059 in) wide, MOPAR Engine Sealant / RTV Silicone Rubber Adhesive (2) to the rear main seal carrier (1). Install the
rear oil seal cover within 10 minutes after applying sealing compound. Do not spread the sealing bead. Only use the approved sealing compound in
the Service Information. Clean sealing surfaces and apply sealing compound to the marked line with a bead thickness of 1.5 ± 0.5 mm (0.059 ±
0.020 in.).
2. Install the rear main seal carrier (1) to the engine block and oil pan.
3. Install the bolts holding the rear main seal carrier (1) to the engine block and oil pan. Torque the bolts to 8 Nm (70 in. lbs.) and then to 10 Nm
(88 in. lbs.).
4. Install the flex plate.
5. Install the transmission.
