Sprinter 2500 V6-3.0L DSL Turbo VIN 45 (2007)
29.
Insert the large red wire with the square electrical terminal from the new relay harness into the open cavity of the original number 10 relay
connector (Figure 11).
30.
Install the red terminal lock into the number 10 relay connector (Figure 4).
31.
Install the number 10 relay removed in Step 8 into the number 10 relay connector.
32.
Install relay number 10 onto location number 10 on the relay support bar (Figure 3).
33.
Install the new relay onto location number 11 of the relay support bar (Figure 3).
34.
Remove the fuse block access cover located on the side of the seat base (Figure 12).