Sprinter 2500 V6-3.0L DSL Turbo VIN 45 (2007)
Headlamp Alignment Switch: Service and Repair
Removal
REMOVAL
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting
any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect
and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further
diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result
in accidental airbag deployment.
1. Disconnect and isolate the battery negative cable.
2. Remove the left outboard air outlet bezel from the instrument panel.
3. From the back of the air outlet bezel (4), compress the latch features on the headlamp leveling switch housing (3) and push the switch out through
the face of the bezel.
4. Remove the headlamp leveling switch from the face of the air outlet bezel.