Sprinter 2500 V6-3.0L DSL Turbo VIN 45 (2007)
Headlamp Switch: Service and Repair
Master Switch
Removal
REMOVAL
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting
any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect
and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further
diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result
in accidental airbag deployment.
1. Disconnect and isolate the battery negative cable.
2. Remove the cluster bezel (3) from the instrument panel.
3. From the back of the cluster bezel, disconnect the vehicle wire harness connector from the connector receptacle on the back of the interior rear
lighting master switch (1).
4. Squeeze the two latch features (2) on the outside of the switch body and push the switch out through the front of the bezel.
Installation
INSTALLATION
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting
any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect
and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further
diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result
in accidental airbag deployment.
1. Align the interior rear lighting master switch (1) with the mounting hole in the face of the instrument cluster bezel (3).
2. Push the switch firmly and evenly into the mounting hole of the bezel until the two latch features (2) on the outside of the switch body snap into
place.
3. From the back of the cluster bezel, reconnect the vehicle wire harness connector to the connector receptacle on the back of the switch.
4. Reinstall the cluster bezel onto the instrument panel.
5. Reconnect the battery negative cable.