Sprinter 2500 V6-3.0L DSL Turbo VIN 45 (2007)
Interior Lighting Module: Service and Repair
Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Insert the tip of a trim stick or a similar wide flat-bladed tool into the notch (2) on one edge of the motion detector lens (1) and carefully pry the
unit downward until it unsnaps from the mounting bracket or the headliner, as the vehicle is equipped.
3. Pull the motion detector down from its mounting location far enough to access and disconnect the vehicle wire harness from the connector
receptacle on the top of the detector housing.
4. Remove the motion detector from the vehicle.
