Sprinter 2500 V6-3.0L DSL Turbo VIN 45 (2007)
2.
Place the ignition key in the "OFF" position.
3.
Disconnect and isolate the negative battery cable ground connection located under the instrument panel, next to the accelerator pedal. This will
disconnect the main battery located under the floor pan (Figure 1).
NOTE:
Some Sprinters are equipped with two batteries. The main battery is located in a battery compartment under the floor pan and the auxiliary
battery is located in the engine compartment. The auxiliary battery has a relay in the positive cable that connects the auxiliary battery to the
vehicle's electrical system only when the engine is running.
WARNING:
Only disconnecting the negative battery cable from the auxiliary battery will not disable the vehicle's airbag system.
WARNING:
Wait two minutes for the airbag system capacitor to discharge before performing this procedure. Failure to take the proper precautions could
result in accidental airbag deployment.
4.
Remove the coat hook located at the top of the "B" pillar.
5.
Remove the grab handle (if equipped).
6.
Remove the tie-down ring from the bottom of the "B" pillar.
7.
Unclip the "B" pillar trim panel from the "B" pillar and set it aside.
8.
Unclip the "A" pillar cover and set it aside.
NOTE:
The "A" pillar cover tether does not need to be disconnected from the "A" pillar