Sprinter 2500 V6-3.0L DSL Turbo VIN 45 (2007)
Stabilizer Bushing: Service and Repair
Installation
STABILIZER BAR BUSHINGS
NOTE: Suspension components with rubber/urethane bushings should be tightened with the full weight of the vehicle at normal ride height.
It is important to have the springs supporting the full weight of the vehicle when the fasteners are torqued. If springs are not at their normal
ride position, vehicle ride comfort could be affected and premature bushing wear may occur.
1. Install the stabilizer bushings to the stabilizer bar.
2. Raise the stabilizer bar into place and install the stabilizer bushing clamps. Tighten the nuts to 149 Nm (110 ft.lbs.).
3. Lower the vehicle.
