Sprinter 2500 V6-3.0L DSL Turbo VIN 45 (2007)
3. Position windshield in center of windshield opening.
4. Apply adhesive tape to the locations shown to aid with final installation.
5. Verify windshield gap is parallel to with windshield.
6. Cut tape with a sharp knife and remove windshield.
7. Clean and dry area of glass to be re-glued with a suitable glass preparation solvent and rag.
8. Using a flash light, verify that glass primer is without damage.
9. Re-prime any damaged area. If old adhesive has been exposed for more than 12 hours, entire adhesive area needs to be re-primed.
10. Allow primer to air dry for at least 10 minutes.
11. Using a flash light, verify that glass primer is without damage.
Windshield Preparation - Installing A New Windshield
1. Clean and check windshield for damage.
2. Position windshield seal onto windshield starting at one corner and quickly moving up and down.
CAUTION: Never moisten windshield seal with lubricants to facilitate installation.
3. Position windshield in center of windshield opening.
4. Apply adhesive tape to the locations shown to aid with final installation.
5. Verify windshield gap is parallel to with windshield.
