Sprinter 3500 L5-2.7L DSL Turbo (2004)
Oil Pan: Service and Repair
OIL PAN
REMOVAL
1. Drain engine oil.
2. Remove the sway bar retaining bolts and swing sway bar down and out of the way.
3. Remove the wiring harness duct from the oil pan bolts and position out of the way.
4. Lower the vehicle and remove the turbocharger upper heat shield.
5. Connect engine support fixture #8534 using adaptors #853416, to the engine lifting eye and raise engine slightly (Fig. 54).
6. Remove engine mounts and raise engine.
7. Disconnect the oil level sensor.
8. Remove the transmission cooler lines from the oil pan bolts and carefully position the lines aside
9. Remove the oil pan bolts.