Sprinter 3500 L5-2.7L DSL Turbo (2004)
Evaporator Temperature Sensor / Switch: Service and Repair
REMOVAL
1. Disconnect and isolate the negative battery cable.
2. Remove the radio.
3. Remove glove compartment.
4. Remove cover from instrument cluster.
5. Remove the instrument cluster.
6. Remove passenger side airbag.
7. Remove cover above air nozzle on passenger side.
8. Remove speaker.
9. Remove center section of instrument panel.
10. Remove A/C-heater control from the instrument panel.
11. Remove instrument panel top section.
12. Remove electrical connections.
13. Remove air bezels from instrument panel.
Evaporator Temperature Sensor
14. Disconnect the wire harness connector from evaporator temperature sensor.
15. Remove evaporator temperature sensor from HVAC housing.
INSTALLATION
1. Install the probe of the evaporator temperature sensor between the fins of the A/C evaporator.
NOTE: The probe must not go into the same hole (in the A/C evaporator) that the probe was removed from.
2. Install the wire harness connector to the evaporator temperature sensor.
3. Install the air bezels to the instrument panel.
4. Install the electrical connections.
5. Install the instrument panel top section.
6. Install the A/C-heater control.
7. Install the center section of the instrument panel.
8. Install the speaker.
9. Install the cover above the air nozzle on the passenger side.
10. Install the passenger side airbag.
11. Install the instrument cluster.
12. Install the cover to the instrument cluster.
13. Install glove compartment.
14. Install the radio.
15. Reconnect the negative battery cable.
