Sprinter 3500 L5-2.7L DSL Turbo (2004)
Cargo Lamp Switch: Service and Repair
INSTRUMENT PANEL
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the accessory switch bezel from the instrument panel.
Cargo Lamp Switch - Accessory Switch Bezel Mounted Remove/Install
3. From the back of the accessory switch bezel, disconnect the vehicle wire harness connector for the cargo lamp switch from the receptacle on the
back of the switch.
4. From the back of the accessory switch bezel, depress the two latches on the outside of the switch body and push the switch out through the front of
the bezel.
INSTALLATION
1. From the front of the accessory switch bezel, align the cargo lamp switch body with the opening in the bezel and push the switch into the bezel
until the two latches on the outside of the switch body snap into place.
2. From the back of the accessory switch bezel, reconnect the vehicle wire harness connector for the cargo lamp switch to the receptacle on the back
of the switch.
3. Reinstall the accessory switch bezel onto the instrument panel.
4. Reconnect the battery negative cable.
BULKHEAD
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Carefully pry the cargo lamp switch and switch bezel out of the switch box on the back of the cargo compartment bulkhead panel.
3. Pull the cargo lamp switch and bezel away from the switch box far enough to access and disconnect the vehicle wire harness connector for the
switch from the receptacle on the back of the switch.
4. From the back of the switch bezel, depress the two latches on the outside of the cargo lamp switch body and push the switch out through the top of
the switch bezel.
INSTALLATION
1. From the front of the switch bezel, align the cargo lamp switch body with the opening in the bezel and push the switch into the bezel until the two
latches on the outside of the switch body snap into place.
2. Reconnect the vehicle wire harness connector for the cargo lamp switch to the receptacle on the back of the switch.
3. Using hand pressure, firmly and evenly press the cargo lamp switch and switch bezel into the switch box on the back of the cargo compartment
bulkhead panel.
4. Reconnect the battery negative cable.
REAR PILLAR
REMOVAL
