Sprinter 3500 L5-2.7L DSL Turbo (2004)
Headlamp Switch: Service and Repair
HEADLAMP LEVELING SWITCH
WARNING: TO AVOID PERSONAL INJURY OR DEATH, ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE
SUPPLEMENTAL RESTRAINT SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, AIRBAG, SEAT
BELT TENSIONER, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE THE
BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE SYSTEM CAPACITOR TO DISCHARGE BEFORE
PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE SUPPLEMENTAL
RESTRAINT SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG
DEPLOYMENT.
REMOVAL
1. Disconnect and isolate the battery negative cable.
Headlamp Leveling Switch
2. Remove the cluster bezel from the instrument panel.
Headlamp Leveling Switch Remove/Install
3. From the back of the cluster bezel, squeeze the two latches on the headlamp leveling switch body and push the switch out through the face of the
bezel.
4. Remove the headlamp leveling switch from the face of the cluster bezel.
