Sprinter 3500 L5-2.7L DSL Turbo (2004)
Lift Arm
5. Disengage lift arm from glass guide rail and remove regulator assembly.
Manual Regulator Fasteners
6. Remove four rivets attaching regulator to carrier plate and remove regulator.
INSTALLATION
1. Install regulator onto carrier plate and install new rivets.
2. Install regulator lift arm into glass guide rail and install regulator assembly.
3. Install carrier bolts and tighten to 10 Nm (89 in. lbs.).
4. Remove glass support.
5. Connect battery negative cable.
6. Verify correct window operation.
7. Install trim panel.
Power
REMOVAL
1. Lower front window approximately 2 cm (3/4 in)
2. Disconnect and isolate battery negative cable
3. Remove door trim panel.
