Sprinter 3500 V6-3.0L DSL Turbo (2008)
Parking Assist Distance Sensor: Service and Repair
Park Assist Sensor - Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the appropriate bumper from the vehicle. See: Body and Frame/Bumper/Front Bumper/Service and Repair/Service Manual/Removal or
See: Body and Frame/Bumper/Rear Bumper/Rear Bumper Cover / Fascia/Service and Repair/Removal.
3. From the back of the bumper (1), disconnect the wire harness connector (4) from the park assist sensor (2) connector receptacle.
4. Disengage the strap (3) from the upper and lower latch features of the bumper receptacle for the sensor.
5. Remove the sensor and O-ring from the receptacle as a unit.
