Sprinter 3500 V6-3.0L DSL Turbo (2008)
1
Phillips screw
2
Front end paneling
3
Phillips screw
4
Phillips screw
5
Auxiliary turn signal lamp
6
Body-bound rivet
7
Bracket
8
Phillips screw
9
Hexagon bolt
10
Internal torx bolt
Removing, installing
1
Remove front bumper
2
Remove front grille
3
Remove lock cross member
4
Remove headlamp
5
Unclip auxiliary turn signal lamp (5) (arrow). Disconnect connector and remove
6
Pull out spreading rivet (6) and remove bumper support (7)
7
Remove sealant between area (A) of wheelhouse and front end paneling
Installation: Replace sealant
Mopar or equivalent body sealant for sealing seams(suitable for painting)
8
Unscrew screws (3) from A-pillar
9
Unscrew screw (4) from wheelhouse
10
Unscrew screws (8, 9, 10)
11
Remove front end paneling (2)
Remove sealant residues
12
Install in the reverse order
Before installing inner front end paneling coat with underbody protection agent Observe uniform gap to engine hood.
Front End Paneling/Models 901.6,902.6,903.6,904.6
Removing and installing front end paneling
MODELS 901.6, 902.6, 903.6, 904.6