Sprinter 3500 V6-3.0L DSL Turbo (2008)
Vacuum Brake Booster: Service and Repair
Power Brake Booster - Installation
INSTALLATION
1. Install the brake booster to the vehicle.
2. Install the booster mounting nuts. Tighten to 25 Nm (221 in.lbs.).
3. Install the push rod pin & clip.
4. Install the brake booster vacuum line and check valve.
5. Remount the HCU on the rubber mounts.
6. Install the master cylinder to the brake booster See: Hydraulic System/Brake Master Cylinder/Service and Repair/Removal and
Replacement/Master Cylinder - Installation.
7. Bleed the base brake system See: Brake Bleeding.
