Sprinter 3500 V6-3.0L DSL Turbo (2008)
9. Remove the fuel pipe bundle and set aside.
10. Remove the oil filter housing support bracket.
11. Remove the cylinder head cover.
NOTE: The left exhaust camshaft gear alignment mark is located in the gear tooth valley. The left intake camshaft gear mark is located on the
outside of the tooth.
12. Check the camshaft timing gears for alignment. The alignment marks should be touching and the exhaust camshaft drive gear alignment pin should
be located at approximately 12 o'clock, when viewed from the front camshaft seal.
13. Rotate the engine by the vibration damper bolt, past TDC to gain access to the lower camshaft drive gear bolt, and remove the bolt.
14. Rotate the engine back to TDC and check camshaft gear alignment.
15. Remove the timing chain tensioner (3).
16. Paint mark or scribe the timing chain to drive gear relation.
